Home › Insights › 24 GHz vs 77 GHz Radar: Which Band Should You Choose?

24 GHz vs 77 GHz Radar: Which Band Should You Choose?

Band selection is a trade-off between range, angular resolution and environment. Here is how the decision actually gets made in engineering practice.

Launston Engineering•2026-10-30•8 min read

Choosing the operating band for a radar module is one of the first decisions an OEM or integrator has to make, and it is frequently made for the wrong reason. The instinct is that "higher frequency is newer, therefore better." In practice, band selection is a trade-off between three variables: how far you need to see, how much angular resolution you need, and what the environment looks like.

The short answer

At Launston we manufacture across 24 GHz, 77 GHz and 80 GHz. In practice the selection follows a fairly consistent pattern:

RequirementTypical bandWhy
Short range, wide field of view, low cost, high volume24 GHzCheapest silicon, widest usable FOV, no license needed in most ISM bands
Medium range with fine range accuracy77 GHzMuch higher bandwidth available, so range resolution improves roughly 3× over 24 GHz
Long range, multi-target, traffic / industrial77 GHz / 80 GHzRange, angular resolution and channel count all scale with available bandwidth
Ultra-compact, cost-sensitive near-field60 GHzShort range but very compact, common in proximity/fuse and short-range AEB
Key principle: bandwidth drives range resolution, and range resolution drives how well you can distinguish two targets at different depths. If your application must separate a pedestrian from a parked truck at 80 m, resolution matters more than the headline detection range.

Why 24 GHz still wins in some segments

24 GHz is not obsolete, and in three specific cases it is the better commercial answer.

1. Wide-angle, short-range perception

Physics works in your favour at lower frequencies: the achievable antenna aperture for a given physical size is larger relative to wavelength, which means a genuinely wider field of view in a small housing. For a two-wheeler or three-wheeler rear blind-spot application, seeing 100° behind the rider at close range matters far more than seeing 150 m forward. Our 24 GHz motorcycle radar is built around exactly this trade-off.

2. Cost and power at volume

For two-wheel and low-speed EV platforms where the radar is sold as an accessory rather than a safety-rated OEM component, the bill of materials is the deciding factor. 24 GHz modules can be produced at a materially lower cost, and they typically draw less power — meaningful on a small vehicle with a shared battery.

3. Regulatory simplicity

24.00–24.25 GHz is an ISM band available in nearly every market without an individual licence allocation. This matters for a manufacturer shipping into 20+ countries: it removes a certification dependency and shortens the time to market for each new region.

Where 77 GHz pays for itself

Move to 77 GHz when the requirement includes any of the following, and the additional cost is usually recovered quickly because it replaces a more expensive sensor stack.

  • Long range with tight accuracy. At 77 GHz, typical automotive-grade modules reach 210–280 m with ±0.1 m accuracy, using 0.2 m range resolution. This is what makes forward collision warning and adaptive cruise practical rather than academic.
  • Multi-target tracking in clutter. A drone flying over a crop field, or a truck in heavy traffic, presents a radar with genuine clutter. More usable bandwidth translates into better angular and range separation, which directly improves the number of simultaneously tracked targets — our UAV-77 tracks up to 64 targets for this reason.
  • All-weather operation. Millimetre-wave radar at 77 GHz is unaffected by visible light, fog, rain, dust and darkness. This is why it is specified for agricultural, mining and traffic applications where cameras fail regularly.

A real selection example

A European agricultural-drone customer approached us for terrain-following and obstacle detection. Their original specification was 24 GHz based on an earlier supplier quote. During our engineering review we measured their actual requirement: they needed reliable detection of tree lines at 90–120 m in rain and dust, across 64 tracked targets, in a unit that had to pass IP67 and weigh under 150 g.

24 GHz could not meet the range-and-resolution combination inside the weight budget. We delivered the UAV-77 platform with a reconfigured antenna and firmware profile: 77 GHz, 80° horizontal field of view, ±0.1 m accuracy, <1.5 W typical power. Same housing envelope, same mounting, but it detects what the mission actually required.

How to decide for your own programme

  1. Write down the worst case, not the typical case. Maximum range at a stated radar cross-section (RCS), in the worst weather you will fly or drive in.
  2. Count the targets you must track simultaneously. Under 8, 24 GHz is usually sufficient. Above 16, move up a band.
  3. Decide how much angular resolution the mounting geometry needs. If the radar must fit in a tight bracket behind a fairing, aperture is limited and the higher band loses some of its theoretical advantage.
  4. Check the interface and power budget last. CAN / CAN-FD, RS485, UART or Ethernet, and the supply voltage your platform already runs, should drive the final shortlist rather than constrain it.
Need a band recommendation for a specific platform? Send us the mounting space, detection distance, target count and interface. Our engineers reply within 24 hours, usually with a specific part number and a budgetary price — no obligation.

Frequently asked questions

Is 77 GHz always more accurate than 24 GHz?

Not in every respect. Accuracy depends on the signal processing chain, not the carrier frequency alone. What 77 GHz reliably provides is better range resolution (roughly 0.2 m versus 0.75 m for a comparable 24 GHz bandwidth) and better angular resolution in a given aperture. Accuracy at a given range is then usually a consequence of that improved resolution.

Does higher frequency mean shorter detection range?

No — it generally means more free-space and atmospheric attenuation at a given range, which is why high-frequency long-range designs compensate with higher transmit power and larger antennas. In practice, a well-designed 77 GHz automotive module reaches further than a well-designed 24 GHz module of the same class, which is why 77 GHz dominates ADAS.

Can I switch bands without redesigning my enclosure?

Frequently, yes. Because Launston develops the antenna, RF front end, signal processing and assembly in-house, we can often retune an existing mechanical envelope to a different band rather than starting from a new reference design. This is the fastest route to a working prototype. See our manufacturing capability.

Which band is best for a motorcycle or three-wheeler?

For rear blind-spot detection at close range with a wide field of view, 24 GHz is usually the better choice. For forward collision warning where you need distance and closing rate at up to 30 m, both 24 GHz and 77 GHz are viable depending on the target mix. See the micromobility radar page for the specification we ship today.

No exact spec match?

We can customize to your detection range, form factor and interface protocol.

Start a custom inquiry